Spot Series
Level: Sets the volume of the overdriven signal.
Duality: Mixes two discrete fuzz circuits. Set it at minimum for a pure gated saw-tooth wave, or crank it up for a tighter high gain fuzz.
Open the magnetic bottom lid to access the controls.
Blend: Mixes the clean input signal with the overdriven signal. The clean signal remains at unity gain while the volume of the overdriven signal is set by the Level knob, allowing for fine control of the blend ratio.
Filter: Controls the amount of high frequency content in the fuzz signal.
Input Impedance: 1MΩ
Output Impedance: 100kΩ
Current Consumption: ~40mA
Voltage: 9V DC (Center Negative)
Width: 50 mm / 2″
Length: 100 mm/ 4″
Height: 45 mm / 1,75″
Weight: 205 g / 0,45 lb
The Duality Fuzz has a current draw of 40mA. Only use a regulated 9V DC adapter with a center-negative plug. Unregulated power supplies and/or higher voltages may result in suboptimal noise performance and even damage your unit, voiding the warranty.
To activate the warranty, we encourage you to register your product on: http://mypedal.darkglass.com and enter the serial number on the back of your pedal. Please contact us via email support@darkglass.com before shipping a product to us.
In the interest of continuous improvement, specifications are subject to change without notice. If you have any questions, please don’t hesitate to contact us at www.darkglass.com The manufacturer claims that the above product fulfils the requirements as set by EN55013, EN55020, EN60555-2, EN60555-3, RoHS, WEEE.
1176®, and SSL® are registered trademarks of their respective companies. Names of factory modes are intended for descriptive purposes only and should not be construed as an endorsement or affiliation with the companies or products named.
This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in residential installations.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. There is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: